Hey,

I am new at building (only built one effect so far, a dallas arbiter fuzz face clone) and am gonna try and breadboard the axis face, but wanna check something first...

I found this layout done by torchy, but apparently it's for the rev 1, and I would like to make it the rev 3 version... 

http://www.indyguitarist.com/torchy/Distortion_Overdrive/Axis%20Face%20-%20Si/Axis_Si.gif

If I use that, then as indicated by the schematic at fuzzcentral, I change the 300R to 1k2, add in the 0.047uF cap in parrallel with the 1k2, add the diode and resistor that go to ground from +9V, change the 2u2F input cap to 0.22uF and take out the 50k trimpot and replace it with a 100k linear taper pot, then take out the bias pot completly (just connect the R7-1 to R7-2&3 with a wire), and make sure the 100pF cap is silver mica, I should have the rev3?

Thanks,

-Adam

EDIT: Typed in a cap value wrong, corrected...